Meta il-klijent tal-klijent staqsa għal sitt naħat protezzjoni ta' il-ġebla, b'sitt naħat protezzjoni kien fil-fatt ipprovdut, u an ibbażat fuq iż-żejt protettiv aġent kien użat għal sitt naħat protezzjoni. Wara is-sitt sitt protezzjoni, a problema arose. The construction workers reported that the stone and cement could be bonded at all.
Kif biex tittratta ma ' problemi wara sitt naħat protezzjoni
If hemm hemm tagħmir tali bħal idejn tħin at the construction site, use the hand grinder to remove all the protective agent on the bottom surface that been protected. It must be completely polished off. If it is not polished off, there will definitely be problems with the stone being hollow or still not sticking after installation.
Jekk il-kundizzjonijiet fuq huma mhux met, hemm hemm ġebel ipproċessar fabbriki, stone sandblasting fabbriki or glass sandblasting fabbriki or glass sandblasting fabbriki near the construction site, li can sandblast the stone li ġie protett minn il-qiegħ ulużjoni blast il- isfel u blast off il is-saff protettiv Madankollu, din spiża hija ħafna għolja u tista ' ma tkunx ekonomika . Mhux permessa fuq.
If il kwantità ta' ġebel is żgħir, a manwal idejn grinder jista' be jintuża għal lustrar off the protective layer on the bottom surface. However, a construction site cannot have only dozens of square meters of stone. This method is only suitable for construction sites with a small amount of stone. Moreover, I used an angle grinder to polish the waterproof back side għax the angle grinder was was too small and the waterproof saff jista ' ma jkunx illustrat nadif. Kien hemm xorta xi wħud żoni fejn is-siment ma kienx mhux marbut.
